New ISMAN Achievement

Slit nozzle (50 x 150 mm in size)
Slit nozzle 50 x 250 mm in size.
Click on the photo, to enlarge it (355x550; 77927 bytes)

At ISMAN, a new process for manufacturing wear-resistant ceramic nozzles for use in sand blasting machines has been suggested. The wear resistance of SHS-produced titanium diboride, silicon carbide and titanium carbide (under standard testing conditions) was found to be higher than that of commercially available tungsten-cobalt alloys by a factor of several dozens.

The method can be used to produce either round nozzles 3-30 mm in the diameter of exit section or slit nozzles up to 50 x 250 mm in size.

We invite you to cooperation in R & D work on this basis. Other forms of cooperation are also possible.

Contact address::
tel.: (095) 962-8007
fax: (095) 962-8040